自行走液壓升降機是目前國內最理想的高空作業設備，整體采用高強度鋁型材精制而成，具有自動行走功能，那么大家在使用時應該注意哪些問題呢？
   
1、自行走液壓升降機http://www.www.hadaja.com/的作業風速應不大于20m/s，在使用時，不能停在傾斜度大于30°的坡上工作，以防升降機下滑。
Self-propelled lifts operating wind speed should not exceed 20m / s, when used, can not be stopped at an inclination of 30 ° slope greater than work to prevent lift decline.
  
2、架設和接高時風速應不大于12m/s，打開總開關后，電量顯示小于40﹪時，要及時充電。充電時要檢查一下電瓶水，若小于20ml，既得加水。
After erection and then high wind speed should not exceed 12m / s, open the master switch, battery indicator is less than 40%, should be promptly charged. To check the battery while charging water, if less than 20ml, vested with water.
  
3、自行走液壓升降機http://www.www.hadaja.com/的正常作業環境溫度應不超出20~40℃，自行走升降機的作業電網電壓波動應不大于士5%供電電網容量應大于70KVA。
Self-propelled lifts normal operating ambient temperature should not exceed 20 ~ 40 ℃, self-propelled lifts operating voltage fluctuations should not exceed ± 5% power grid capacity should be greater than 70KVA.
  
4、嚴禁超載運行，單個吊籠不帶對重時載重1t,帶對重時載重2t，新裝的液壓升降機必須進行滿載墜落試驗,以后至少每三個月一次。
Do not overload run, single hoists without counterweight when the load 1t, with a heavy load when 2t, newly installed elevator full drop test must be carried out after at least once every three months.
  
5、自行走液壓升降機導軌架最大自由高度應不大于9m，簡易自行走式液壓升降機所用的馬達，要能承受極頻繁的啟動、停止和換向作用;能在重載下起動，就是要有較高的起動轉矩，以及較小的起動電流。
Maximum freedom to go their own lift rail rack height should not exceed 9m, simple self-propelled lift motor used to be able to withstand extremely frequent starting, stopping and reversing effect; to be started at heavy loads, is to have a higher starting torque, and a small starting current.

液壓升降機：http://www.www.hadaja.com/